The size of CNC bicycle Front Rear Disc Brakes is standard. The brake Handle lever is used at the two ends of the handlebar with a diameter of 22mm. The brake caliper is suitable for 160/180mm brake rotors. To make the distance between the sheets adjustable. When the brake pad is worn, just adjust the knob to reduce the distance between the two brake pads, so that your brake feel is always in the best state, and you can keep the excellent feel for a longer time.However, when the wear reaches a certain degree, it is recommended to replace the brake pad immediately. Type: hydraulic mountain bike disc brake (internal SHIMAN0 mineral oil). Caliber: 22mm outer diameter handlebar (applicable to all bicycles). Adjusting knob for brake pad distance: when the brake pad is worn, you only need to adjust the knob to reduce the.
To replace the brake pad. CNC bicycle disc brake caliper Suitable for rotor. 160mm/180mm(6-pin, universal for medium lock disc).
(If installing 203mm rotors need to change seat). Mountain bike hydraulic disc brake hose Length. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness. Please allow slight manual measurement deviation for the data.
Also, the each additional item means. The the same color and size.
Transit time may be a little delayed because of the. If you have any questions. This item is in the category "Sporting Goods\Cycling\Bike Components & Parts\Brakes".The seller is "marketstrends001" and is located in this country: CN. This item can be shipped worldwide.