Disc brake stopping power for your Ford 9 inch or 8 inch rearend at nearly the same cost as rebuilding/replacing drum brakes, Kits includes two bolt-on caliper brackets, two 11-1/4" vented rotors, two GM metric style calipers (non-emergency brake), brake pads and hardware for increased stopping power, Fits over an axle with maximum flange diameter of 6-1/4" O. Rotors have a 2.780" center hole with both 5 on 4-1/2" and 5 on 4-3/4" bolt circles, Fits "old" and "new" style big bearing 3.150" bearing O. Ford housings and with axle offsets of a minimum 2-3/8" to 2-1/2". Speedway Ford 9 Inch Rearend Bolt-On Rear Disc Brake Kit. For passenger car axles only, 15 and larger wheels only.
Fits 9 inch housing axle offsets of 2-3/8 to 2-1/2 (measured from outside of housing flange to outside of axle flange, not measured out to axle register but only surface where the rotor sits against). Requires big bearing housing ends for a 3.150 O.Bearing with 3/8 bearing retainer bolt holes. Brake rotor has a 2.78 center hole and works with axle shaft flanges no larger than 6-1/4 diameter. If your axle shaft flange exceeds that diameter, you will need machine the flange to decrease the diameter. This kit is an aftermarket solution. It is not intended to be a direct installation or OEM replacement. Due to changes in production in certain years, your application may require modifications beyond these instructions for this kit to install properly. Disc Brake Stopping Power at a Great Value.
This economical disc brake kit for Ford 9 inch and 8 Inch axles is simple to install and provides big stopping power, at a price nearly the same as replacing original drum brakes. That Ford rear end handles the power to make it go, but these binders clamp down when you say whoa! Todays average family sedan can stop from 60 MPH in 120 feet, at nearly 1G of deceleration. You need the same stopping power. Your passengers, you and your car deserve the confidence of disc brakes and our kit delivers that confidence with exceptional value.
Aftermarket disc brakes are superior to original drums in many ways: more braking force, less brake fade, and easier service. Stopping power starts with our newly manufactured GM Metric D154 style single piston calipers, commonly found on 1978-88 GM G-Body and A-Body cars. Large 11-1/4 diameter, 1 thick vented rotors provide more stopping leverage than common 9 or 10 drum brakes. Brake pads are easier to change than drum shoes, and our brake kit includes a street-friendly organic compound for long rotor/pad life.
Replacement pads are common sized, available from your local auto parts store. Looking for more aggressive stopping power? We carry race-grade D154 disc brake pads that drop in just as easily.
Fits Ford 9 Inch and 8 Inch Housings. This disc brake kit fits Ford 8 inch axles, as well as passenger car Ford 9 inch axle housings with big bearing ends 3.150 O.
Bearing, found on passenger cars from 1974-79. Included bracketry will adapt this kit to both new style and old style Ford 9 inch housing flanges with the 3/8 bearing retainer bolt holes.
Bracket spacers are also included, allowing this kit to work with axle flange offsets of 2-3/8 or 2-1/2 common on Ford 9 inch passenger car rear ends. Axle flange offset is measured from the axle housing flange face (with bearing retainer removed) to the axle shaft flange face (side where the brake rotor/drum rides, including the thickness of the axle flange). Kit includes a detailed, step-by-step instruction sheet with images.
The floating calipers include new Grade 5 slider bolts, with all remaining hardware of Grade 8 quality. Cast iron rotors feature a dual bolt pattern in 5x4.5 (Ford/Mopar/AMC) or 5x4.75 (Chevy/GM) to match your desired wheel hub pattern.
Plus, this assembly will clear most 15 diameter wheels designed with disc brakes in mind. Note that there are no provisions for a parking brake, making this the perfect disc brake conversion kit for the budget-focused builder who prefers a basic upgrade kit. Disc brake stopping power at nearly the same cost as rebuilding/replacing drum brakes. 11-1/4 diameter, 1 thick vented cast iron rotors dissipate heat faster than drum brakes.
Serviceable design ensures good drivability and piece-of-mind when on the road. Street-friendly GM D154 style pads, replacements available nearly everywhere.
GM Metric style single piston calipers with 7/16-20 banjo-style inlets. Fits Ford big bearing 9 inch housings from passenger cars and 8 inch rear ends.
Use with Ford 9 inch rear ends with 2-3/8 or 2-1/2 axle flange-to-housing offsets. Dual wheel bolt patterns covering all GM/Ford/Mopar (5x4.5 for 1/2 studs, 5x4.75 for 7/16 studs).
Use with 15 or larger disc brake-style wheels. Easy bolt-on installation w/ included instruction sheet. Includes heavy steel mounting brackets, Grade 8 hardware and nylock nuts (everything you need). "Old-style" big bearing 9 Ford axle. "New-style" big bearing 9 Ford axle.Axle housings with minimum axle offsets of 2-3/8" to 2-1/2". The exception would be the late 50's station wagon rear ends. When using with a Currie Axle with an o/d register of 2.795", the rotor is included in this kit with an i/d register of 2.78" and therefore will need to be machined by increasing the hole diameter in the rotor to match the Currie axle spec of 2.795. Works with 8" Ford and new and old style big bearing Ford 9" using 3/8 retaining bolts. Nice set-up for a ford 9 inch good quality.
Yes, I recommend this product. By Manny on March 23, 2019. Speedwaymotors is the best place to get your performance parts.Ford inch rear disc brake kit. By Shawn on December 26, 2018. Kit was complete and ready to go. You will have to "clean up" the hole a bit if you want them to fit over speedways/Curries 9+ axles. Use a stone bit and just hit them it will work fine.
Do not use a carbide bit it will cut to fast. When building custom hot rods it's important to remember EVERYTHING needs to be fit. By Chuck on July 31, 2018. The directions were difficult too understand as well as photographs were hard to see and figure out.But i got it after trial and error. By Tank on November 15, 2017. Related Items / Suggested Parts. Ford 9 Inch Bolt-On Rear Disc Brake Kit w/ E-Brake. T-Bolt Kit w/ Nuts for Ford 9 Inch Rear End Housings. Speedway 8 & 9 Inch Ford Disc Brake Conversion Kit w/ E-Brake. Dot Braided Stainless Brake Hoses, GM/Ford, 7/16-20 Rear. Redline 80402 CV-2 Synthetic Grease. Please take advantage of the add to cart button on each listing to get everything in your cart prior to completing checkout. Speedway Motors is Americas Oldest Speed Shop® and has been a trusted source for specialty rodding and racing products and friendly expert advice for more than 68 years.
Repack the item in a sturdy box, include a copy of your invoice and complete the form on the back of the invoice. Speedway accepts full responsibility for the accuracy of our listings and product representation. The item "Speedway Ford 9 Inch Rearend Bolt-On Rear Disc Brake Kit" is in sale since Sunday, March 29, 2020. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Brakes & Brake Parts\Discs, Rotors & Hardware". The seller is "speedway_motors" and is located in Lincoln, Nebraska.
This item can be shipped to United States, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, South Korea, Indonesia, Taiwan, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Mexico, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica, Aruba, Belize, Dominica, Grenada, Saint kitts and nevis, Turks and caicos islands, Bangladesh, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Liechtenstein, Luxembourg, Monaco, Macao, Martinique, Nicaragua, Peru, Pakistan, Paraguay, Viet nam, Uruguay.